2. x6mm
4
2.3x6mm
3.
Center the aileron servos and connect the ball link to the ball end on each control horn. Use the
quick
keeper
to secure the rod to the servo horn as show (A,B). Screw or unscrew the ball link as
required to
get
the aileron level with the wing trailing edge with the servo centered.
D.
C.
4
.
Push the supplied carbon wing joining spars into the slots of the fuselage (A), longer one at the front,
and the shorter one at the rear. Ensure the spars do not catch on any wires when passing through the
fuselage. Once inserted, ensure both are centered as show (B).
5
.
Maintaining their aligned position, slide one wing panel onto the spars and into place on the fuselage.
Handle with care, as you may need a good firm push to get the wing fully into position. Repeat with the
remaining panel (A). With both panels firmly in place, secure with four of the
2.5x6mm screws as shown (B).
B.
A.
A.
B.
A.
B.