Duracraft AMD-67E, Инструкция пользователя, Страница: 7 / 78

ENGLISH
6
• Press the " " button until the cooling mode is shown is the LCD-display .
• Select the desired fan speed by pressing the " " button (low, medium, high).
• If the room that is to be cooled down is being exposed to sun close the
curtains. Place the air conditioner far from any other heat source.
Assembly instructions for exhaust air tube and nozzle (Fig. 11)
• Slide the exhaust air hose onto the connector at the back of the appliance.
• Put the hose through an open window to the outside. Close the window as
much as possible.
• If you would like to install the hose through the wall, drill a hole of 131 mm
diameter through the wall and push the hose through the hole to the outside.
• The exhaust air hose can pulled and turned in almost any direction.
4. Dehumidifying
• Keep doors and windows shut to improve the dehumidifying performance.
• Make sure that the water tank is in place.
• Select the dehumidifying mode by pressing the " "-button until the " "
symbol illuminates in the LCD display.
• The exhaust air tube must be located outside (e.g. through an open window or
hole in the wall) so that the warm air can be discharged.
5. Ventilation
• Select the ventilation mode by pressing the " "-button untíl the " "
symbol illuminates in the LCD display.
• Select the desired fan speed by pressing the " " button (low, medium, high).
6. Timer function and setting
• When the appliance is off but the supply cord is plugged in press the " " but-
ton. "Timer On" is being shown in the LCD-display. Select the desired time
by pressing the "
" or " " buttons, e.g. 6 hrs. The appliance automatically
starts operating after 6 hrs.
• When the appliance is operating press the " "-button. "Timer On is being
shown in the LCD- display. Select the desired time by pressing the " " or " "
buttons, e.g. 2 hrs. The appliance automatically stops operating after 2 hrs.
7. Automatic oscillation of air deflectors
• When the appliance is operating press the " " button until the " " symbol is
shown in the LCD display. The vertical air deflectors start oscillating from left
to right. Press the "
" button once again. The symbol disilluminates in the
LCD display and the air deflectors stop oscillating.
8. Water tank
• When operating the appliance in dehumidifying or cooling mode condensate
water is being drained into the water tank. If the tank is full an alarm signals
sounds and the red light illuminates. The appliance stops operating after 3
minutes. Empty the water tank and put it back.
Caution: Do not remove the water tank when dehumidifying or cooling. If doing so
the alarm signal will sound and the compressor stops working.
If you would like to empty the tank before it is full switch off the appliance. Wait at
least 3 minutes before removing the tank to avoid condensate water enter the
appliance.
9. Constant water draining (Fig. 7)
• Pull out the constant water drain at the side of the appliance. Do only pull it out
for this purpose as otherwise it becomes leaky. Make sure that the drain is not
clogged.
• Hold the drain firmly and slide the condensate water tube onto the drain.
• Make sure that the tube is not bended.
Caution: When the appliance is operating or has just been switched off the
constant water drain must not be pulled out as it could be full or water.
10. Air Filter (Fig. 8)
The air inlet grille is equipped with an active carbon and dust filter.
1. Grille
2. Dust filter (filters dust from the air)
3. Active carbon filter (filters odours from the air)
CLEANING AND STORAGE
• Before cleaning switch off the appliance and unplug the appliance.
• Do not use petrol, paint thinner or other chemicals to clean the appliance.
Cleaning of the body (Fig. 10)
• Only use a soft, damp cloth to gently wipe the appliance clean and dry it with
soft cloth.
Air filter (Fig. 9)
• Clean the filter once every two weeks.
• Pull out the grill at the handle, pull it up and take it out.
• Carefully take off the 6 plastic plates and remove the filter from the grille.
• Gently wash the filter in 40 degree warm water with a neutral detergent.
Let the filter thorougly dry; do not expose to sunlight when letting it dry.
• Put the dry filter carefully back in place and fix it to the grille with the six
plastic plates.
Water tank
• Remove the water tank, empty it and wash it with approx. 40 degree warm
water. Fully dry the tank and put it back in place.
Storage
• Empty and dry the water tank.
• Remove the stopper from the water tube inside the appliance. Let the water
fully drain and replace the tube back into the appliance.
• Clean the appliance as described above.
• After draining the water operate the appliance in ventilation mode for several
hours to thorougly dry it.
• Fold up the supply cord and tighten it at the back of the appliance.
• Cover the appliance with a plastic bag.
Disposal
This symbol on the product or its packaging indicates that the appliance
cannot be treated as normal domestic trash, but must be handed in at a
collection point for recycling electric and electronic appliances.
Your contribution to the correct disposal of this product protects the environment
and the health of your fellow men. Health and the environment are endangered by
incorrect disposal.
Further information about the recycling of this product can be obtained from your
local town hall, your refuse collection service, or in the store at which you bought
the product.
This regulation is valid only in EU member states.