DURA-BILT DFSOC-10, Инструкция по сборке и установке

Страница: 5 / 16

Mounting Rail Installation
Note: The RV Rail may be slightly shorter than the Mounting Rail.
Note: this product is sold in maximum section widths of 4’ and will be assembled in the fi eld from the
supplied components. If it’s necessary to shorten the Slide Out Cover any or all panels can be cut, and
extrusions shortened. Front Trim should be shortened at the joint, not at left or right end, due to
factory machining.
1 . Determine where the Slide Out Cover is to be positioned along the RV Rail and mark that location on the
RV Rail.
2 . Before sliding the Mounting Rail into the RV rail, spray the RV rail cavity with a lubricant such as furniture
polish.
3 . Slide the Left End Mounting Rail section into the RV Rail until
it reaches the mark made previously.
4 . Mark the locations of all RV studs or solid support
(normally 16” on center) on the bottom leg of the Mounting
Rail. Drill 7/32” holes through the Mounting Rail at the
locations you marked.
5. Apply caulk to the back side of the Mounting Rail bottom
leg before attaching with screws.
Page 4
6. Attach Mounting Rail to the RV with a #12 x 1-1/2” Hex Screw to keep the Mounting Rail from moving
when the Panel Hinge is installed.
7 . Using the same procedure, install any remaining sections of Mounting Rail.
8 . Install the #12 x 1-1/2” Hex Screws in the remaining holes that you previously drilled.
RV
Rail
Mounting Rail
Mounting Rail