Duplo DSF-2000, Инструкция по эксплуатации

Страница: 53 / 64

50
1
2
3
4
5
6
7
1
2
3
4
5
6
7
A
Set the rear guide A at the rear of the paper stacked.
If the stacked paper is lower than the rear guide such as when only a small amount of paper is stacked, raise the paper feed
tray A. (Refer to “5-2. Up/Down Operations of Paper Feed Tray”.)
The rear guide A need not be set at this point, but can be set just before the paper feed tray is raised and the separator air
is blown out during test feeding.
4
15. STACKING PAPER ON THE PAPER FEEDER A AND ADJUSTING PAPER FEED
Adjust the height of the level sensor A.
The standard position of the level sensor A is as
shown in the figure.
Moving the level sensor A knob to the lower arrow
side raises the paper feed position. Moving to the
upper arrow side lowers the paper feed position.
If mis-feeding occurs easily with thick paper, adjust
to the lower arrow side. If double-feeding occurs
easily with thin paper, adjust to the upper arrow side.
5
Level sensor A
Adjust the amount of separator air to
separate the paper using the separator air
adjustment knob A.
The larger the number, the greater and more powerful
will the separator air blown out be.
The standard position of the separator air is “2”.
When using large art paper or coated paper, adjust the
separator air adjustment knob to a large setting. When
using thin small paper, adjust the separator air
adjustment knob to a small setting.
6
Adjust the height of the separator A using
the separator adjustment knob A.
The larger the number, the wider will the gap between
the separator A and suction belt be. And the smaller
the number, the small will the gap be.
The standard position of the separator A is “3”.
If mis-feeding occurs easily when actually feeding
paper, adjust the separator adjustment knob to a large
setting. If double-feeding occurs easily, adjust to a
small setting.
7
Separator air
adjustment knob A
Separator
adjustment knob A