Duplo DC-616, Руководство по обслуживанию

Страница: 124 / 210

122
Chapter 6 2 Conditions for the Error Detection
S2-Y1540
No paper
PPS1 is in the “light through” state when the <START> or <TEST> key is pressed.
J2 Feed tray
Both the elevator lower/upper limit switches are turned on.
J3 Feed error
The paper does not reach the PPS2 even if the feeding operation is performed for three times.
J4 Slitter
The paper does not reach the PPS3 even if it is fed by 400 mm after passing through the
PPS2.
J5 Cut.crease
The PPS3 is kept in the “light blocked” state even if the paper is fed by 820 mm after the cut
and crease process being completed.
The paper does not reach the PPS4 even if it is fed by 75 mm after the cut and crease process
being completed.
J6 Exit tray
The PPS4 is kept in the “light blocked” state even if the paper is fed by “registration paper
300 mm” during processing.
J7 Waste box
The margin jam sensor is in the “light blocked” state for the con fi gured period (800 ms) during
processing.
E00 Main-Panel
The main panel does not respond to the inquiry from the control panel within 6 seconds.
E01 CCD
A communication error occurs in the barcode scanner operation.
E02 Elevator
After the driving signal of the elevator is output, it dose not reach either the upper or lower
sensor within 10 seconds.
E03 Crease lower
The encoder output does not change (H/L) even if the creaser lower blade motor is started.
The HP of the lower blade cannot be detected within 10 seconds after the creaser-driving
signal is output.
E04-06 Memory error
There is no response from the memory (write/read error)
E07 Connect error
The connection between the main PCB and drive PCB is incorrect.
The input to the main PCB from the drive PCB cannot be con
fi rmed.
E08 FPGA ERROR
Program writing is not successful.
2 Conditions for the Error Detection
-0