DBM70 Instruction ver 1.doc
Page 5
3/12/01
4.1 Loading Staples :
1.
Only those staples sold or recommended by your supplier should be used in the DBM-70. Use
of non recommended staples may damage the stapling heads and they are not covered by any
warranty.
2.
Raise the top cover.
3.
Raise metal locking bar upwards and remove spent cartridge. Ensure the bar is in the
uppermost position otherwise the cartridge may not load properly.
4.
Make sure that staples do not protrude past the staple tear line. If necessary the staples are
easily torn off at the tear line by tearing downward.
5.
Cartridge should be placed flat on the slide in the body of the stapler and pushed firmly
forward. Do not allow the cartridge to move backwards once inserted into the stapler. If this
occurs remove cartridge from stapler and tear off staples at tear line again before re-inserting.
6.
To keep the cartridge in place push metal locking bar down until it snaps into the grove on the
back of the cartridge.
7.
Press staple out reset button, lower top cover and press circuit re-set button located below the
on/off button.
8.
The staples do not immediately feed through to the plunger and therefore the machine will not
staple during the first three or four cycles after loading. Where this is a problem, refer to 10
below.
9.
To avoid books being processed without staples, cycle the machine by placing scrap paper
beneath the heads. Repeat this until staples appear in the paper.
Содержание DBM-70
Страница 1: ......
