~ 7 ~
~ 8 ~
11) Remove the handles and replace with all knife bolts.
12) Trying to put the knife to the left side until the position of knife
beam equal to the cutting stick. Then tighten all knife holding
bolts.
13) Remove all tools. Turn off the knife change switch. The knife
carrier and the clamp will automatically return to its top position.
14) Test cut a full stack of paper. If the bottom sheets are not cut,
then adjust the knife micro adjustment clockwise. This will lower
the knife towards the cutting stick.
Note:
(1) When making a cut and the guillotine is beeping, you need to
check the following:
(a) The knife is blunt.
(b) The clamp pressure adjustment is too low.
(c ) A thick paper pile height (over) is used.
(2) When you turn on the knife change switch, at the same time,
the foot clamp pedal switch is no function.
Warning for Knife Change:
When you complete
3,000
cuts
operation, it will beep “PI” “PI” -----
at intervals of one second, at this time you have to replace a sharp
blade for use, after replacing the blade, the alarm will disappear. If
you don’t want to change the blade, please turn on the knife change
switch to the knife change position and then make a knife change
operation, the sound disappears. Then the counter will resets to
zero and re-start.
ADJUSTMENT FOR THE SIZE OF REAR POSITION
If there is a difference between the actual cut size and the back
gauge display size, it indicates the rear position is incorrect. Make
the required adjustment as the following procedure:
1. Re-switch on the machine and move the back gauge to the rear
position, then to measure the size with a rule (by metric system).
Adjust the rear position size by call out program set “0”, adjust
the first setting figure to the correct size.
2. Cut a piece of paper to two even parts. (Cut paper size 200 mm
into two 100 mm paper)
3. Put the outside paper on the inside one and make a comparison
between these two parts.
4. If the inside paper is larger than the outside one, you have to
increase the correction size (i.e. 0.5mm, then do the adding 0.5
to the rear position).
5. If the inside paper is smaller than the outside one, the
correction size should be decreased and do the subtracting.
6. When the correction is made, turn the power off and back on.
inside
＞
outside (make the correction to add)
inside
＜
outside (make the correction to subtract)
