Dumor Aerocard-Strike, Руководство пользователя

Страница: 45 / 48

Geelseweg, 80 | 2250 | Olen | BELGIUM | Tel. +32 (0) 14 25 92 83 | henry.dumor@hotmail.com | www.dumor.be
45
Setting the linear tools
Access is via the outfeed cover with interlock switch.
The
upper body of the tools are screwed to the cross bar, note there are 2 alternate holes on each tool in case you
are near the end of a slot.
The tool is positioned according to the mm scale and lining up with the dots on the body which indicate the blade
centre line.
The
counter roller is positioned centrally under the tool blade or the pip on the scoring wheel and lightly tightened
using a 2,5 mm Allen key on the grub screws onto the flat of the output shaft.
Note that over tightening the screws will distort the roller giving uneven pressure and mark the shaft.
The upper tools are lowered to kiss the roller using the pressure screw.
Only a very light pressure is needed, a heavy pressure will damage the roller and tool.
Slit tool setting
The slit tools blade flat edge will kiss the side of the counter roller.
Note that in order to ensure that the cards run straight and true under the tools the tool should be positioned at
the mid point of the card or the card may skew .
Helper rollers
28
Rubber outfeed rollers should be set equispaced on both sides of the linear tool to ensure grip and straight feed-
ing.
Note that the outfeed rollers need to have sufficient grip to ensure the sheet is pulled from the crease tool and
particularly the perfing comb or a infeed jam will occur.
LOWER ROLLERS
Re-tooling the lower rollers
The output shaft can be withdrawn from the machine by:
- Removing the small spring clip
31
- Sliding the shaft to the right by 2 cm and exposing the gear.
- Pulling the left side outwards by about 5 cm and sliding to the left to dislocate the bearing.
If you need to re- tool the shaft the end clip can be removed and the bearing slid off to allow the counter wheels to
be slid off.
Refitting is the opposite procedure.
Do not loose the spring clips as they are tiny !
Outfeed table
Setting the inclined outfeed table.
Take a sample of the final product and lay it on the tray.
Set the side guides and separators to about 5 mm of the sheet to give it room to slide in.
Business card tray
Setting the business card tray
The outfeed table is to be set horizontally.
The tray is positioned to fit on the 2 pips and pushed against the end of the machine.
The deflectors are positioned to guide the card into the tray without hitting the guide.
Note that when using narrow gutter the space between the cards is tight...
The card side guides are slid into position using a trial card to ensure the correct setting,
or the cards will catch on the guides back up and cause a jam.
The setting is minute.