Dumor Aerocard-Strike, Руководство пользователя

Страница: 44 / 48

Geelseweg, 80 | 2250 | Olen | BELGIUM | Tel. +32 (0) 14 25 92 83 | henry.dumor@hotmail.com | www.dumor.be
44
Waste bin
26
The waste bin collects the gutters and cross cut waste material.
The bin will be full after about 3 hrs of full time use.
Do not let the waste back up or the paper path will jam up.
Finishing tools settings
8
8
Fitting the slide in cross tools
Access via the door with interlock switch.
Press the retaining clip to the right and withdraw the tool.
To insert another tool the tool will need to be squeezed to fit into the slot.
The clip will click when the tool is fully home , if the tool is not fully home a warning message will occur.
The tools handle ensures a one way fitting and the tool cannot be fitted inverted or it would cause a jam.
Linear tool works bottom up.
Setting the cross tools pressure
Done by the screen.
There are also 3 pressure screws to balance the line depth across the sheet.
These control the height and pressure of the tools on the paper.
These screws are factory set and usually require no adjustment.
If they need to be altered the increment is 1/10 of a turn on all screws equally and re-test on a new sheet.
Important :
If the depth is set too tight the gap will be too small and the paper will jam at the infeed to the bar.
Note that the perf bar is thicker than the crease bar and the pressure bar will need to be set about 2 positions less
on the screen.
UNJAMMING
How to unjam the slitters
Use the reverse button to slightly disengage the paper from the head and pull the paper away, make sure no small
pieces are trapped in the slitter.
Note if the jam is very bad the upper slitter head may need to be removed to remove the scrap lodged in it.
How to unjam the cross tools (usually an accordean style jam).
Use the reverse button to pull the paper back a little.
Pull the paper away.
LINEAR TOOLS