5
RFHU - Multiuse Operator’s Manual
IMPORTANT SAFETY INSTRUCTIONS
The following warnings and cautions appear throughout this manual and should be
carefully observed.
• Turn the unit off, disconnect the power source and allow unit to cool down before
performing any service or maintenance on the unit.
• The procedures in this manual may include the use of chemical products. You must read
the Material Safety Data Sheets before using any of these products.
• The unit should be grounded according to local electrical codes to prevent the
possibility of electrical shock. It requires a grounded receptacle with dedicated electrical
lines, protected by fuses or circuit breaker of the proper rating, in accordance with all
applicable regulations.
• Disposal of the unit must be in accordance with local environmental codes and/or any
other applicable codes.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
• Contains Transmitter Module FCC ID: 2AQ2Q-MUR1LVUFL
• Contains Transmitter Module IC: Still need.
• This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation.
• This equipment complies with radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum
separation distance of 20cm between the radiator (enclosed antenna) and your body.
• This device is granted for use in Mobile only configurations in which the antennas used
for this transmitter must be installed to provide a separation distance of at least 20cm
from all person and not be co-located with any other transmitters except in accordance
with FCC and Industry Canada multi-transmitter product procedures.
• Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
