Dukane Infinity 43NSLA, Быстрый старт

Страница: 33 / 65

SE
CTION 4
| C
ONTR
OLS
AND
I
NDICA
TORS
Infinity™ Series Servo Ultrasonic Press Systems QUICK START GUIDE
29
Removing the Module Block from the Stack
Before separating stack components, observe the following:
• To maintain structural integrity, NEVER hold a transducer by the housing or the booster by the mounting rings while
separating components. Doing so will result in damage to the unit.
• Use only the tools recommended by Dukane. NEVER clamp a horn, booster, or transducer in a vise or use tools such
as pliers, vise grips, etc. Doing so will result in scratches and/or gouges, resulting in stress areas on the surface. This
condition will affect the stack operation and could lead to failure of each stack component.
To separate the stack components, follow the instructions below:
1. remove the (4) screws from the bottom of the booster clamp block as shown in Fig. 4-37 below, then remove the
U-shaped block.
2. remove the booster block by sliding the block back over the transducer to the left as shown in Fig. 4-38.
Figure 4-37 Booster Clamp
Figure 4-38 Booster Block