29
QM00481-1
Remote control
Changing the frequency of remote control signal
The accessory remote control has the two choices on signal frequency Mode
1:NORMAL and Mode 2:HIGH. If the remote control does not function properly,
attempt to change the signal frequency.
To set the Mode, press
the combination of two buttons listed below simultaneously
for about three seconds.
(1) Set to Mode 1:NORMAL
MENU
and
MY BUTTON-4
buttons
(2) Set to Mode 2:HIGH
RESET
and
MY BUTTON-1
buttons
The REMOTE FREQ. in the SERVICE
item of the OPTION menu (
99
) of the projector to be controlled should be set to
the same mode as the remote control.
INFO
NETWORK INTERACTIVE
(1)
MY
BUTTON-4
button
MENU
button
(2)
MY
BUTTON-1
button
RESET
button
Using the REMOTE ID function
Use this function to control specific projectors by the remote
control assigned the same ID number when you use multiple
projectors of the same type at the same time.
Assign an ID number to each projector before using the
REMOTE ID item in the SERVICE menu of the OPTION
menu (
99
). Press the
ID
button with the same ID number
as assigned to the projector you are going to control. The
ID
button selected lights for several seconds.
• Each time you press any button (except
ID
buttons), the
ID
button of
current selected ID number lights.
• To confirm the projector's current ID, press any
ID
button for three seconds.
Its number is shown on each screen regardless of set ID of projector.
NOTE
INFO
NETWORK INTERACTIVE
ID
buttons
