9
1. Introduction
Terminals
2
7
3
1
4
5
8
11
12
13 10
6
9
1. HDMI 1 IN Terminal (Type A)
(
→
,
)
2. HDMI 2 IN Terminal (Type A)
(
→
,
)
3. DisplayPort IN Terminal
(
→
)
4. COMPUTER IN/ Component Input Terminal (Mini
D-Sub 15 Pin)
(
→
,
5. COMPUTER AUDIO IN Mini Jack (Stereo Mini)
(
→
,
6. HDBaseT IN/Ethernet Port (RJ-45)
(
→
,
7. HDBaseT OUT/Ethernet Port (RJ-45)
(
→
,
8. AUDIO OUT Mini Jack (Stereo Mini)
(
→
,
)
9. USB-A Port (Type A)
(
→
)
10. LAN Port (RJ-45)
(
→
)
11. 3D SYNC Terminal (Mini DIN 3 Pin)
(
→
)
12. PC CONTROL Port (D-Sub 9 Pin)
(
→
)
Use this port to connect a PC or control system.
This enables you to control the projector using serial
communication protocol. If you are writing your own
program, typical PC control codes are on page
.
13. REMOTE Terminal (Stereo Mini)
Use this terminal for wired remote control of the pro-
jector using the remote control, RD-465E.
Connect
the projector and our remote control, RD-465E,
using a commercially available wired remote
control cable.
NOTE:
• When a remote control cable is connected to the REMOTE
terminal, infrared remote control operations cannot be per-
formed.
• When [HDBaseT] is selected in the [REMOTE SENSOR]
and the projector is connected to a commercially-available
transmission device that supports HDBaseT, remote control
operations in infra-red cannot be carried out if transmission
of remote control signals has been set up in the transmission
device. However, remote control using infrared rays can be
carried out when the power supply of the transmission device
is switched off.
Содержание 6765WUSS
Страница 72: ......