Duerkopp Adler 4280-2, Инструкция по эксплуатации

Страница: 8 / 34

5
3.1.10 Dismantling of the hook post
When dismantling the post (1), the supplies of lubricating oil are to be
disconnected first, the fastening screws unscrewed and, thereafter, the
post is removed.
Caution ! Danger of injury!
Switch off the main switch! Before starting the setting
operation, wait until the motor stops!
- Unscrew the screw (2).
- Push the lubricating tube (3) downwards into the post.
- Disconnect the hose (4) with the wick.
- Loosen only one screw (5).
- Unscrew the screws (6).
- Shift the post in the sense of the arrows and remove it out from the
machine.
- When mounting it, proceed inversely. Make sure that the wicks in the
tubes are in contact with the other wicks leading oil into the box (7).
3.2 Needle and thread mechanism
3.2.1 Description
The take-up lever (1) is mounted in ball bearings, both at the spot of its
suspending on the connecting rod (2) and in the mounting on the loop
(12). The take-up lever is of aluminum and is provided with a stuck-in
eye for two threads. The connecting rod (2) is mounted on the eccentric
pin (3), by means of which the thread mechanism is adjusted for a big
or a small hook. The needle bar holder (4) is mounted through the pin
(5) in a rotating way in the arm (6). In its top part, the holder is guided
by the guide pin (7). The movement for the needle feed is given to it by
the connecting rod (8) driven by the feeding shaft (9). The connecting
rod (8) is mounted by eccentric pin (13) with needle bar holder (4).
The connecting rod (10) of the needle bar (11) on the loop (12) is
mounted in a ball bearing and it is slidingly mounted on the needle bar
carrier. The mechanism is lubricated by means of a central-wick
lubricating system.
3.2.2 To check the handwheel angular adjustment
The handwheel (5) must be situated in its precise position relative to
the needle and thread mechanism. This position is given by a pin (2),
which locks the connecting rod of the needle rod (1) through a hole in
the arm (3). In this position, the indicator (6) of the handwheel must
show „O“. The position is fixed by the handwheel screw (4) contacting
a small flat surface provided on the upper shaft.
The correct adjustment of the angular position has been car-ried out at
the producer‘s.
Caution ! Danger of injury!
Switch off the main switch! Before starting the setting
operation, wait until the motor stops!
6
11
4
5
10
9
12
8
3
7
2
13
1
2
3
4
5
6
0
o
1
5
6
6
3
2
1
7
1