9
INSTRUCTION FOR THE INSTALLER
INSTALLATION
The appliance is designed to be embedded into
heat-resistant pieces of forniture.
Make a hole in the top of the piece of forniture with
the dimension indicated in the last page of this
booklet at a distance of at east 50 mm from the
appliance border to the adjacent walls.
Adhesive washer “S” slong the border of the
topbottom (fig.3).
Block it with the fastening hooks “C” (fig.4).
ELECTRICAL CONNECTIONS (fig.5)
Before carryng out electrical connection be sure
that the characteristics of the electrical system
meet the specifications of the located at the
bottom of the work-top and the electrical system is
provided with effective ground in compliance with
the regulations and provision of the law in force.
The ground is binding according to the law.
If the appliance is not provided with cable and/
or relative plug, apply a standardized plug to the
power supply cable.
If you wish a direct connection to the line, it is
necessary to interpose a means for disconnection
having a contact separation in all poles that
provide full disconnection under overvoltage
category
III
conditions. It must be incorporated in
the fixing wiring, according with the wiring rules.
ATTENTION
Should a built-in oven or any other appliance
producing heat be fitted directly under a
glassceramic cook-top with Touch Control, it
is necessary isolate the hob whith a separator.
The bottom temperature must be low 60°C.
Disregard of this precaution could cause the wrong
working of the Touch Control system.
The operations indicated below must be followed by qualified personnel exclusively, in conformity
with the regulations in force.
The manufacturing firm refuses all responsibility for damages to people, animal or things, resulting
fron the failure to comply with such provisions.
