18. Operation and repairs
Periodic control of the harness condition will keep it in safe operation for a long time. After each hard landing check the back
protector, as the seams or zip quite often get ripped on absorbing impact. and damaged protector will be ineffective. If you notice any
damage to its cover, send it back to the producer for a repair or buy a new one. Correspondingly, after each use of rescue chute
thoroughly check entire harness for damages, paying particular attention to the straps and seams.
Aluminium carabiners should be replaced each 5 years or 300 hours airtime. Scratched or damaged carabiners are not serviceable
anymore and have to be replaced at once.
Using damaged harness is out of the question. In case of any doubts please contact your dealer or manufacturer and/or send it to an
authorised workshop for closer inspection.
i
The Funky harness has an airworthiness certificate for 10 years since the date of production.
The AF-15/2018 protector used in the harness is airworthy for 10 years from the date of production.
Environmental care
Paragliding is an outdoor sport. We believe that our clients share our environmental awareness. Exercising paragliding you can easily
contribute to environment preservation by following some simple rules. Make sure you don’t harm the nature nature wherever we
can stay. Keep to marked paths, do not behave loudly, do not litter, respect the delicate balance of nature,
Recycling of used gear
A harness is made out of synthetic materials, which need to be properly utilised when worn out. If you are unable to take care of right
disposal, DUDEK Paragliders will do that for you. Just send your harness to the address given at the end of the manual, accompanied
by a short note.
31
Содержание Funky 2018
