7.1 Shoulder straps
Thanks to adjustable shoulder straps (1) the harness can accommodate pilots of almost any height. They should stay on your
shoulders rather tight, with just a little play. Too short straps will make comfortable seating after launch difficult, and can limit your
movement in flight. A clip on the shoulder traps makes sure they stay in place during launch and flight. Additionally, there is an alarm
whistle fixed to the clip. You can use it to summon help in danger.
7.2 Side straps
They determine the seat/backrest angle. Initial adjustment should be done before the first flight, with the harness hanged from a
ceiling. In order to increase comfort, the Funky features an additional adjustment in the lumbar part (6). You can increase the support
of the lumbar spine by shortening the adjustment line, moving the red ball up until enough. All settings are to be verified during first
flight and can be further modified at any time. Bear in mind that when the backrest is reclined too much, there is increased risk of
getting twisted in case of a big deflation.
7.3 Leg straps
The leg straps are the most important safeguard against falling out of the harness. Their adjustment must allow for easy launching
and proper seating in the air. Too short straps can make you uncomfortable and restrain your starting run. Too long straps can make
seating into harness without using your hands impossible. In the Funky harness both leg straps (3) are joined with the chest strap,
thus significantly reducing risk of launching without leg straps closed.
In the Funky strap system the leg straps double as lateral stabilizers of the harness. Shortening of those straps limits the side swings of
the harness.
23
Содержание Funky 2018
