Ducati Diavel Carbon, Руководство пользователя

Страница: 87 / 213

86
LAP registration function
This function describes the ”LAP” time registration.
If the function is activated (see “LAP activation/
deactivation description), the lap time can be
registered as follows:
- pressing the flash headlight button (11, fig. 12) the
first time starts the “lap timer” for the first lap,
and the instrument panel shows the message
“LAP-START” flashing for 4 seconds, and then
returns to the previous display;
- from this moment, each time that the flash is
pressed (11, fig. 12) the display automatically
shows the lap number and lap time for 10
seconds and then returns to the ”previous”
display.
You can save a maximum of 30 laps in the memory.
Once the memory is full, the instrument panel no
longer stores lap times when the flash headlight
button (11, fig. 12) is pressed, and the flashing
message “LAP-FULL” is shown on the display for 4
seconds until the times are reset.
When the LAP function is set disabled, the current
”lap” is not stored.
If the LAP function is active and suddenly the
motorcycle is suddenly turned off (Key-Off), the
function will be automatically disabled (even if the lap
timer was active, the current ”lap” is not stored).
If the time is never ”stopped”, it will roll over upon
reaching 9 minutes, 59 seconds and 99 hundredths;
the lap timer starts counting from 0 (zero) and will
keep running until the function is disabled.
If however the LAP function is switched on and the
memory has not been cleared, but fewer than 30 laps
have been saved (e.g. 18 laps), the instrument panel
will store any remaining laps until the memory is full
(in this case, it will store an additional 12 laps).
This function only displays the times for the lap being
registered; but other data are also saved (MAX speed
and MAX rpm) for viewing at a later date in the “LAP
DATA” function (stored LAP display).