![background image](http://html1.mh-extra.com/html/ducati/ctr31/ctr31_instruction-manual_2537575029.webp)
29
ENGLISH
G) Programming the board
Step-by-step logic
Condominium logic
Automatic logic
Cyclical mode
Opening slow-down exclusion logic
Set the dip switch 1 to OFF.
Set the dip switch 2 to ON.
The state of the other dip switches
has no effect.
Set the dip switches 1 e 2 to OFF.
The state of the other dip switches
has no effect.
Set the dip switch 1 to ON.
The state of the other dip switches
has no effect.
Set the dip switch 4 to ON.
The state of the other dip switches
has no effect.
Set the dip switch 3 to ON.
The state of the other dip switches
has no effect.
Radio-command codes self-learning :
Press the
P1
push-button once to insert a “Opening Start” code; press the
P1
push-button twice to insert a
“Closing Start” code; press the
P1
push-button three times to insert a “Pedestrian Start” code”. Each time the push-button is pressed, the led DL1
flashes in acknowledgement. Subsequent pressures of the
P1
push-button must be spaced by 1 sec. minimum periods. When the led is lit with a fixed
light transmit the code to be learn by means of the radio-command.
Warning :
In
Ciclical mode (dip switch 4 = ON)
the opening start and closing start commands become, respectively, start and pedestrian start.
Erasing all stored codes :
Press push-button P1 until the led DL1 goes off (about 10 seconds).
Setting the work time :
Make sure the gate is completely closed. If not, position it manually. Press push-button
P2
for about 3 seconds (the led DL1
will light with a fixed light) until the gate starts opening at a reduced speed. During this phase adjust the speed by means of the trimmer
RV1
to obtain
the desired slow-down. When the gate is completely open press push-button
P2
again and wait for the led DL1 and the blinker to go on with a fixed
light.
You adjust the RV1 trimmer to half of run
and then press push-button
P2
repeatedly (3 times) to program the following operations :
1) motor M1 start in closure
2) motor M1 slow-down start
3) motor M1 stop (end of travel and end of programming)
Note :
if the unit is connected to the closing limit switch it is not necessary to press P2 in order to stop the motor.
Setting the pause time :
Press push-button
P3
until the led DL1 lights. Let the desired pause time pass, then press push-button
P3
again.
3 2 1
5 4
ON ON
OFF OFF
3 2 1
5 4
ON ON
OFF OFF
3 2 1
5 4
ON ON
OFF OFF
3 2 1
5 4
ON ON
OFF OFF
3 2 1
5 4
ON ON
OFF OFF
Содержание CTR31
Страница 1: ...1 MANUALE D ISTRUZIONI INSTRUCTIONS MANUAL MANUEL D EMPLOI...
Страница 45: ...45...
Страница 46: ...46...