Operate adjustments and settings only with garage door in closed position, and
make sure any object child or person will be in the operating zone
To activate the door automatic closing programme, rotate the “TIME” trimmer anti-clockwise from 0 posi-
tion, until the desired time pause interval is reached. The adjustment range is 0-100 sec. Your door will
automatically close after the programmed temporized pause.
Position= 0 (trimmer completely rotated clockwise) will activate the step-by-step function = opens - stop -
closes.
The garage opener setted in automatic closing functio will not accept remote control/ keypad or key
switch impulse while in pause time.
WARNING:
If you set the automatic close operating function, the risk of
injury of people or damage to objects increases !
In order to prevent injuries: never leave or permit to leave any object or
car in the operating zone of your door mooving zone. Neve leave chi-
drens without parental contol or adults nearby the door if you set the auto-
matic closing function.Allducks recomends to use step by step function.
Page 20
Courtesy light:
The courtesy light on the electronic board can be replaced with the following model:
Halogen lamp 20V 24W
Remote control batteries:
The duration of remote control batteries is approx. 2 years.
Batteries can be replaced with the following model:
12V type A23 - 5mA
Protection fuse:
In the event of short circuit, the protection fuse can be replaced with the following type:
Fuse 5x20mm 1A T fast ( see on draw.40, page 14)
1) Opener does not operate:
- check electric power supply.
- check the protection fuse and, should it be necessary, replace it
- check motor function by triggering it through the start contact (see drawing)
- check that the remote control code is stored in the opener board (erase all memories first and then
store the code)
- The batteries could be discharged. Replace them.
2) The opener opens but does not close:
- If the photo beams are not connected, check that the bridge between outlets 4 and 5 is appropriately
connected.
- if photo beams are connected, check their alignment and that they are clean both inside and outside
- also check that no automatic closing function has been programmed. Should this be the case, the
system will not accept closing commands.
3) The system does not operate from remote beyond a certain range
- there may be interferences in the air. The use of an external aerial antenna is recommended.
4) The door does not close in the desired position
- check that there is no excessive friction at a specific door position
- check the power level, and eventually increase it
- check limit switch settings
0
sec.
=step by step
100
sec.
TIME
13. Automatic closing
14. Maintenance
15. Quick Help to Problem solving
Draw.49
!
