Ducasa AVANT-DGi+ 1000, Инструкции по эксплуатации и монтажу

Страница: 6 / 16

6
INSTALLATION INSTRUCTIONS
Electrical Connection
A qualified electrician must carry out the electrical installation of this radiator. The electrical installation must
comply with the current UK regulations. Any claim on the warranty could be invalid if these requirements have
not been met.
The radiator requires a 230V 50/60Hz power supply.
Connecting wires:
Brown: Live
Blue: Neutral
Yellow-Green: Earth (Not present on low level models because of Class II)
The connecting wires must be of the appropriate section, in regards to the length of cable, type of cable
and power rating of the radiator.
The radiator must be connected into a fused connecting box or a plug fitted with an appropriate sized fuse
for the radiator – see Technical Data on Page 3.
We recommend that the connecting box is positioned 10cm to the right of the radiator and at a height
recommended by current UK regulations.
According to regulations, the radiator must be connected to the power supply by means of an all-pole circuit
breaker with a contact gap of at least 3mm or by a thermal-magnetic circuit breaker.
Location
The ideal place to site the Ducasa radiator is as close as possible to coolest wall in the room but it is not
recommended to site the radiator on un-insulated exterior walls, in this case, the part of the wall behind the
radiator should be insulated.
In bathrooms, the radiators must not be sited inside the protected areas. The control unit switches must not
be reachable, directly or indirectly, by a person in the bath / shower or using the wash basin.
The radiator, under no circumstances, should be installed below an electric power point.
Choose the location of the radiator in respect of the minimum distances that are indicated in Figure A.
Note: If the window sill protrudes less than 20mm the gap above the heater can be disregarded.
window sill
150mm.
150mm. min.
unobstructed space each side
150mm.
Fig. A