14
15
Pour away solution, wipe around the surface with a cloth and
rinse well by pouring clean water into the Water Recess. Pour
the water towards a front corner to ensure that no water goes
into the Air Vent. Rinse the Water Recess a minimum of three
times.
Failure to do so can cause injury. Do not operate
Steriliser with descaling solution in it.
TIP: Follow these few simple steps to minimise
limescale build up in your Steriliser: Empty the
Steriliser after each use; do not allow water to stand in
the Steriliser overnight. Use filtered water instead of
tap water.
U
N
PL
UG
AFTER
U
SE
- F
IRE R
ISK
U
N
PL
UG
AFTER
U
SE
- F
IRE R
ISK
4
2
2
5
6
Use a Philips 2 screwdriver
to undo the screw holding
the Filter Holder into
position. Remove Filter.
Unplug the Steriliser from
the mains and allow to cool
down completely before
descaling.
Replace the Filter in the
Steriliser Base.
Remove Filter and rinse
under a tap while carefully
brushing with soap suds
and a soft brush or lint-free
cloth until all visible dust
is removed.
Warning:
Do not operate the
Steriliser unless the
Filter is in position. Risk
or fire.
The Steriliser can be descaled by pouring just-boiled water
into the Water Recess up to the MAX marker, then adding
30ml of Kilrock Espresso & Coffee Machine Descaler. This can
be purchased on www.dualit.com.
Caution: Be aware of
splashing. Risk of scalding and chemical inhalation.
Place the Filter Holder back
in position and tighten the
screw.
Warning: If filter
is torn, cracked or
damaged in anyway do
not use your Steriliser,
risk of fire.
Call customer
services on 01293 652500
to purchase a replacement.
3
3
Dry the Filter with a lint-
free cloth. Allow to fully
dry before replacing in the
Steriliser Base.
Leave to stand for 20
minutes.
1
1
4
CLEANING THE FILTER
Clean your Steriliser Filter at least every month.
Caution: A blocked or dirty Filter will affect the Steriliser’s performance.
DESCALE REGULARLY
Important Notice: Product failure due to the build up of limescale is not
covered by guarantee.
The Steriliser needs to be descaled regularly. As a minimum it is recommended that you
descale your Steriliser once a month in soft water areas, every 21 days in medium water
areas and every 14 days in hard water areas. You can check your water hardness with your
water provider.
Wear rubber gloves. Do not use on marble surfaces. Do not put
descaler bottle down on work surfaces. Wipe descaler bottle after use.
