DTS XR2000 SPOT CMY, Руководство пользователя, Страница: 10 / 48

8 - VOLTAGE AND FREQUENCY
The XR2000 SPOT with electronic ballast can operate at 90-260 VOLT 50 or 60 Hz.
9 - INSTALLATION
XR2000 SPOT may be either floor or ceiling mounted.
For floor mounting installations, the XR2000 SPOT is supplied with four rubber mounting feet on the
base.
For ceiling mounted installations, we reccomend the use of appropriate clamps to fix the unit to the
mounting surface.
The supporting structure from which the unit is hung should be capable of bearing the weight of the
unit, as should any clamps used to hang it. The structure should also be sufficiently rigid so as not to
move or shake whilst the XR2000 SPOT is moving.
Eight 1/4 turn Fast Locks connections placed in the base of the unit allow to fix the XR2000 SPOT in any
position, by using the two Fast Lock “C” clamps provided in the box.
.
9.1- Safety cable
We recommend the use of a safety cable connected to the XR2000 SPOT and to the suspension truss in
order to avoid the fixture accidentally falling should the main fixing point fail. Make sure that the iron
cable can bear the weight of the entire unit.
You may attach the safety cable to the two holes (A) located on the base of the fixture, as shown in the
picture below.
9.2- Protection against liquids
The projector contains electric and electronic components which should under no circumstances come
into contact with oil, water or any other liquid. The proper unit functioning would be compromised
should this occur.
A
!
240 mm
107 mm
10
XR2000 SPOT