DTS XR2000 BEAM, Руководство пользователя

Страница: 10 / 40

8- VOLTAGE AND FREQUENCY
The XR2000 BEAM with electronic ballast can operate at 90-260 VOLT 50 or 60 Hz.
9- INSTALLATION
XR2000 BEAM may be either floor or ceiling mounted.
For floor mounting installations, the XR2000 BEAM is supplied with four rubber mounting feet on the
base.
For ceiling mounted installations, we reccomend the use of appropriate clamps to fix the unit to the
mounting surface.
The supporting structure from which the unit is hung should be capable of bearing the weight of the
unit, as should any clamps used to hung it. The structure should also be sufficiently rigid so as not to
move or shake whilst the XR2000 BEAM is moving.
Eight 1/4 turn Fast Locks connections placed in the base of the units allow to fix the XR2000 BEAM in
any position, by using the two Fast Lock ‘C’ clamps provided in the box.
.
9.1- Safety cable
We recommend the use of a safety cable or chain connected to the XR2000 BEAM and to the suspension
truss in order to avoid the fixture accidentally falling should the main fixing point fail. Make sure that the
iron cable or chain can bear the weight of the entire unit.
You may attach the safety chain to the two holes (A) located on the base of the fixture, as shown in the
picture below.
9.2- Protection against liquids
The projector contains electric and electronic components which should under no circumstances come
into contact with oil, water or any other liquid. The proper unit functioning would be compromised
should this occur.
ARC 1200
10
A
XR2000 BEAM