SMS-2K-1 Digital Cinema Server Maintenance Manual
Version 1.0
5 Maintenance Tasks Procedure
Caution
: Maintenance tasks should be performed by a technician accredited by
DTS Digital Cinema.
5.1 Tasks Required each 5,000 Operating Hours
Each 5000 operating hours, the maintenance tasks procedure presented in this paragraph must
be performed. Follow the steps detailed below.
5.1.1 Unit Preparation (estimated duration: 20 minutes)
For the following preventive maintenance tasks, the Digital Cinema Server unit has to be
removed from its operating location and put in a safe area as presented below:
1. The power should be disconnected: power off the unit and unplug both power cables.
Note
: You might have to disconnect other cables in order to put the unit in a proper place for
this operation.
2. Remove the Digital Cinema Server from its rack and put it in a location (e.g. a desk) where
you have room to perform the procedure.
3. The lid needs to be removed. Remove six screws with the Phillips tip screwdriver: two on
each side and two on the rear panel of the chassis.
Rear panel screws
side screws
side screws
Figure 5: Digital Cinema Server - Lid Screws Location
When these screws are removed, slide the lid from the front side to the rear side of the Digital
Cinema Server unit in order to remove it from the chassis, as shown on
Slide the cover to
the rear side of the
chassis
Figure 6: Digital Cinema Server - Lid Removal
Note
: Make sure to keep the six black screws in a secure location as they are needed to
close the chassis at the end of this procedure.
5.1.2 Dust Removal
14
Document #: 9301H29500V1.0
