DTS DRIVENET 1664, Руководство пользователя

Страница: 44 / 47

User Manual
Ver. 1.00 42 di 43
DRIVENET
15 Troubleshooting
Warning: Make sure to unplug the devices from their power supply when connecting/disconnecting cables.
Problem Probable cause Possible solutions
The DRIVENET, after
installation, doesn’t
turn on.
Wrong main connection
•
Check the DRIVENET’s correct connection to
the mains.
•
Plug the DRIVENET power cable into a known
working power outlet.
•
Swap the DRIVENET power cable with known
working cable.
• Check the correct Input voltage / Frequency
range
The DRIVENET suffer
from crashes and or
display corruption
Overheating or excessive
wear
•
Check the DRIVENET fans to ensure that it is
operating normally, and there is good air flow
through the unit.
• If the fans are blocked by dust, use a
compressed air duster or brush and a common
vacuum cleaner to safely remove the dust.
The LEDs intensity of
the connected
projectors to
DRIVENET is too low
Too many devices
connected or wrong setup
• Make sure the DRIVENET is not overloaded by
having too many devices connected to it.
•
Make sure the DRIVENT is set up correctly.
• Make sure that the used cables have a proper
section and that their length is inferior to the
maximum length possible.
• Make sure that connections are properly made.
Flickering of the
connected projectors
Wrong input power
Too many devices
connected to the same
output
•
Make sure the DRIVENET has proper input
voltage
• Make sure DRIVENET are not overloaded and
that they are working inside their proper
operating temperature range and voltage range.
•
Make sure that connections are properly made.
•
Make sure the DRIVENET is not overloaded by
having too many devices connected to it.
If the problem persists or the product doesn’t work as specified, please contact the nearest authorized support
center or refer directly to D.T.S. Illuminazione Srl.