2.6. Registering remote with Galactic function
To register remote with Galactic function
authentication codes of the receiver and remote must
be compatible.
To register remote press and hold for 5 seconds two
buttons of the remotes, in receiver radio range.
Successful registering indicates C1 LED blink three
times. To activate the remote at the receiver's
memory, press any button on the remote.
CZAS
2
C1 LED
BLINK 3 TIMES
PRESS ANY
BUTTON
TO ACTIVATE
Fig. 5.
Registering remote with Galactic function.
REMOTE IN RECEIVER RADIO RANGE
2.4. Entering Galactic authentication code to NANO receiver
To enter an authentication code to receiver it is
necessary to have remote with programmed
authentication code.
To enter an authentication code to receiver press the C1
button twice. LED goes out for 8 seconds. During this
time press and hold for 5 seconds two buttons of the
remote. Successful entering of the code indicates the
C1 LED that blinks three times. From that moment the
r e c e i v e r h a s a u t h e n t i c a t i o n c o d e s e t a n d
programmable remotes with Galactic function can be
added.
If within 8 seconds after pressing C1 button twice, the
code is not entered, or code entering fails, the LED will
not blink three times but immediately light up.
2.5. Removing Galactic authentication code from NANO receiver
To remove the authentication code it is necessary to have a remote which the code has been entered.
To remove the authentication code press C1 button twice. LED goes out for 8 seconds. During this time press and
hold two buttons of the remote. Successful removing of the code indicates the C1 LEDs blink three times. If within
8 seconds after pressing C1 button twice, the code is not removed, or code removing fails, the LED will not blink
three times but immediately light up.
Memory format removes the authentication code from receiver.
2
1
1
PRESS TWICE
C1 BUTTON
C1 LED
GOES OUT
FOR 8 SEC
PRESS AND HOLD
FOR 5 SEC
TWO BUTTONS
ON THE REMOTE
C1 LED WILL
BLINK 3 TIMES
CODE ENTERED
SUCCESSFULLY
4
Fig. 4.
Entering Galactic authentication code.
C1 LED
GOES OUT
3x
Failure in registering may be caused by:
4
incompatibility of authentication codes in
receiver and remote,
4
low battery of the remote,
4
radio interference during the procedure,
4
full memory of the receiver (attempt to
enter 201 remote).
BLINK
2x
1
3
PRESS AND HOLD
FOR 5 SECONDS
TWO BUTTONS
OF THE REMOTE
3x
BLINK
