Fig. 6.
Removing single remote.
PRESS AND HOLD
C1 BUTTON
ON THE RECEIVER
C1 LED
BLINK
PRESS ACTIVE
BUTTON
OF THE REMOTE
C1 LED
GOES OUT
REMOVING
SUCCESSFUL
2
1
1
4
BLINK
3
2.7. Removing single remote
While holding receiver C1 button, press active button
on the remote. If removing is valid, LED goes out.
Holding receiver button for more than 15
seconds will erase memory.
2.8. Memory format.
To format receiver memory, press and hold for 15
seconds receiver C1 button. Release the button when
LED light goes out.
Memory format:
- removes all remotes from the receiver,
- sets easy remote registering function
unlocked,
- removes the authentication code from
the receiver.
1
1
Fig. 7.
Memory format.
2.9. Verifying number of registered remotes
To verify number of registered remotes, prior registering or removing remote is required.
After registering or removing remote, hold receiver button for 5 more seconds. LED will blink showing number of
registered remotes. First number of tens (from 0 to 20 long pulses), then number of units (from 0 to 9 short pulses).
Fig. 8.
Pulses example, showing number of registered remotes - 46.
number of tens - 4x10
number of units - 6
WARRANTY
DTM System provides operational and ready to use devices. The producer gives 24 months warranty from the
selling date to the end customer. This time is counted according to the producer warranty labels or serial numbers
placed on every product. Producer obliges himself to repair the device for free if during the warranty period there
are problems which come because of his fault. Broken device should be supplied on customer's expense to the
place of purchase and enclose clear and brief description of the breakage. The cost of mount/dismount is covered
by the user. The warranty does not cover: batteries in the remote controls, faults caused by improper usage, user
self repairs and adaptations, lightning strikes, voltages or short circuits in the electrical grid. Appropriate legal acts
regulate details of the warranty.
spółka z ograniczoną odpowiedzialnością spółka komandytowa
C1 LED
BLINK
C1 LED GOES OUT
- FORMAT SUCCESSFUL
PRESS AND HOLD
C1 BUTTON FOR
15 SECONDS
15 SECONDS
The intention of the WEEE Directive (Directive 2002/96/EC on waste electrical and electronic equipment) is to reduce the
amount of hazardous substances in waste. The underlying purpose is to promote the avoidance, recovery and risk-free
disposal of waste.
DTM System hereby declares that the radio receiver complies with Directive 2014/53 / EU. The full text of
the EU Declaration of Conformity is available at the Internet address.
