AMI BIOS Setup
31
Power Management/APM
Set this option to Enabled to enable the power management and APM (Advanced Power
Management) features.
The settings are Enabled, Inst-On or Disabled. The default settings are Disabled.
Instant-on Support
Set this option to Enabled to allow the computer to go to full power on mode when leaving a
power-conserving state. This option is only available if supported by the computer hardware.
AMIBIOS uses the RTC Alarm function to wake the computer at a prespecified time. The
settings are Disabled, 1 Min, and all one minute intervals up to and including 15 Min. The default
settings are Disabled.
Green PC Monitor Power State
This option specifies the power management state that the Green PC-compliant video monitor
enters after the specified period of display inactivity has expired. The settings are Off, Standby, or
Suspend. The default settings are Standby.
Video Power Down Mode
This option specifies the power management state that the video subsystem enters after the
specified period of display inactivity has expired. The settings are Disabled, Standby, or Suspend.
The default settings are Standby.
Hard Disk Power Down Mode
This option specifies the power management state that the hard disk drive enters after the
specified period of display inactivity has expired. The settings are Disabled, Standby, or Suspend.
The default settings are Disabled.
Hard Disk Timeout (Minute)
This option specifies the length of a period of hard disk inactivity. When this period expires, the
hard disk drive enters the power-conserving mode specified in the Hard Disk Power Down
Mode option described on the previous page. The settings are Disabled, 1 Min(minutes), and all
one minute intervals up to and including 15 Min. The default settings are Disabled.
Standby Timeout (Minute)
This option specifies the length of the period of system inactivity when the computer is in Full-On
mode before the computer is placed in Standby mode. In Standby mode, some power use is
curtailed. The settings are Disabled, 1 Min, 2 Min and all one minute intervals up to and
including 15 Min. The default settings are Disabled.
Содержание PAM-0073I
