DTK PAM-0073I, Руководство пользователя

Страница: 32 / 48

Chapter 4
26
Quick Boot
Set this option to Enabled to instruct AMIBIOS to boot quickly when the computer is powered
on. The settings are:
Setting Description
Disabled AMIBIOS test all system memory. AMIBIOS waits up to 40 seconds for a
READY signal from the IDE hare disk drive. AMIBIOS waits for .5
seconds after sending a RESET signal to the IDE drive to allow the IDE
drive time to get ready again. AMIBIOS checks for a <Del> key press and
runs WINBIOS Setup if the key has been pressed.
Enabled AMIBIOS does not test system memory above 1 MB.
AMIBIOS does not wait up to 40 seconds for a READY signal from the IDE
hard disk drive. If a READY signal is not received immediately from the
IDE drive, AMIBIOS does not configure that drive. AMIBIOS does not
wait for .5 seconds after sending a RESET signal to the IDE drive to allow
the IDE drive time to get ready again.
You cannot run WINBIOS Setup at system boot, because there is no delay
for the Hit <Del> to run Setup message.
Table 2
The Optimal and Fail-Safe default settings are Enabled.
Boot From SCSI/IDE
This option sets the boot device (SCSI or IDE). The default setting is IDE.
BootUp Sequence
This option sets the sequence of boot drives (floppy drive A:, hard disk drive C:, or a CD-ROM
drive) that the AMIBIOS attempts to boot from after AMIBIOS POST completes. The setting are
C:,A:,CDROM, CDROM,C:,A:, or A:,C:,CDROM, etc.
The default settings are A:,C:,CDROM
BootUp NumLock
Set this option to Off to turn the Num Lock key off when the computer is booted so you can use
the arrow keys on both the numeric keypad and the keyboard. The settings are On or Off. The
default settings are On.