DTK PAM-0070S, Руководство пользователя

Страница: 44 / 72

Chapter 4
38
Onboard Parallel Mode: Choose SPP, EPP/SPP, ECP, ECP/EPP Mode. Make proper selection
with the attached printer port device.
ECP Mode Use DMA: Choose “1” or “3” to select the DMA channel used for the ECP device.
This item is shown if the Onboard Parallel Mode is chosen as “ECP” or “ECP/EPP” option.
Parallel Port EPP Type: Choose “EPP1.7” or “EPP1.9”, which is used to configure the EPP
using either EPP1.7 or 1.9 timing specification. This item is shown if the Parallel Mode is
chosen as “EPP” or “ECP/EPP” option.
USB Controller: Choose Enabled or Disabled. “Enabled” allows the on board Universal Serial
Bus (USB) Controller to be functioned.
USB Keyboard Support: This option only shown when USB controller is enabled. Choose
Enabled or Disabled to support the USB K/B or not.
Ring Power Up Control: Choose Enabled or Disabled. “Enabled” allows the ring in signal
(Modem) waking up the system.
4.8 LOAD SETUP DEFAULTS MENU
This Main Menu item uses the default setup values. Use this option as a diagnostic aid
if the system behaves erratically. Choose this item and the following message appears:
“Load SETUP Defaults (Y/N)? N”
To use the Power-On defaults, change the prompt to “Y” and press <Enter>.
4.9 SUPERVISOR PASSWORD
Two level of password is supported. Depending on the setting of the “Security Option”
in the “BIOS FEATURES SETUP”, the system BIOS will ask for password every time
booting up the System or entering BIOS Setup. With the supervisor password, both the
system booting and BIOS setup changing is allowed.
This main menu item lets the user to set up the Supervisor Password.