DTC COMMUNICATIONS, INC.
5
4
Slide the control panel door open (to the right).
5
When power is applied, the transmitter will power-up to its last state.
Ensure that the green RF LED turns ON indicating the unit is
transmitting. If needed, push the RF button to begin transmitting.
The channel number LED also turns ON, representing the most recent
channel setting from the last time the transmitter was used.
6
If you need to change the operating channel, press the CONFIG button
to cycle through the 8 available channels indicated by the channel
number LEDs. Refer to the Programming section on page 10 for more
information on channel settings. When you change the channel
configuration, the RF transmission is automatically switched OFF to
prevent accidental interference. When you have selected the channel
you need, push the RF button to start transmitting again. The RF LED
will turn ON.
NOTE:
A red ALARM LED indicates that no video is connected.
Your Transmitter is now operational. Confirm its signal with your
Palladium Receiver.
WARNING
: Do not apply power to the transmitter unless an antenna
or non-radiating load is connected to the Antenna SMA connector.
NOTE
: The RF switch should remain ON during normal use. The RF
automatically shuts off during programming to prevent accidental
transmissions on unintended frequencies.
4
5
6
QUICK START
Palladium Pd-TX-100 Transmitter,
Front View
Optional Data and
Chaining Connector
