the connection line between wire detector and general controller should not exceed 3m, and should
install detector out of the way.
DOORBELL REMOTE
CONTROLLER
1. operation: install it out of the door and use it as remote control doorbell, press the key,
general controller will give Dingdong Dingdong to remind host open door. It can not
operate other function of the general controller.
2
．
Attention: avoid installing the unit on metal base.
4-KEY REMOTE CONTROLLER
1
．
operation
1.1 press the panic alarm key, general controller will give panic alarm and the 8 LEDs on
the left and light all light.
1.2 press time-delay fortify key, general controller will give DI
…
DI
……
, Fortify LED flash once a second, after 60s, it give DI DI DI
then sound stop, it enter fortify state, Fortify LED flash once 2s.
1.3 press quick fortify key, general controller give DI and it enter
fortify state, Fortify LED flash once 2s.
1.4 press cancel key, you can cancel above operation, general
controller give DI DI, that indicate operation has been canceled.
2
．
Attention: avoid installing the unit on metal base.
WI
RELESS DETECTOR DPS-55
1
．
Jumper setting (like right
figure)
1.1 Sense once to emit:
sense once, the sensor emit
signal , 15S later after it emit
signal, sense once again, the
sensor emit signal again.
1.2 Sense twice to emit:
sense twice, the sensor emit signal , 15S later after it emit signal,
sense twice again, the sensor emit signal again.
This setting
enhance its preventing false-alarm and preventing-pet
function.
2. test
2.1 press the fortify key on 4-key remote controller, set the general controller on fortify state.
2.2 set the jumper on needed position;
2.3 install 9V battery, after 60s the sensor enter stable working state;
2.4 move along the tangent of the lens, sense it, the sense LED light and then it emit signal to general controller, the
emission LED light;
2.5 after receiving emission signal, general controller give alarm(>90db), the alarm time delay is 3Min 30s, provided
that its corresponding channel is channel 3, the Ch3 should light(press cancel key on 4-key remote controller to stop
alarm quickly).
EMISSION
LED
BATTERY
COVER
PANIC ALARM
TIME-DELAY FORTIFY
QUICK FORTIFY
CANCEL
4-KEY REMOTE CONTROLLER
EMISSION LED
EMISSION KEY
DOORBELL REMOTE CONTROLLER
BOTTOM COVER
INSTALLING HOLE
INSTALLING HOLE
CROSSING-LINE
HIDDEN HOLE
INSTALLING HOLE
INSTALLING HOLE
CROSSING-LINE
HIDDEN HOLE
PRESS HIDDEN HOLE WITH POWER TO OPEN
BOTTOM COVER FIGURE(BACK)
2
3
OPEN FRONT COVER FIGURE
FRONT COVER
TIGHTEN OFF
SCREW
1
PUSH BACK THE
FRONT FCOVER
PULL UP THE
FRONT COVER
AUTO
DIP switch
Sense LED
PIR
Jumper
AUTO / 1
AUTO / 1
1
Emit LED
Sense
once to
emit
Sense
twice to
emit
Low-battery LED
