EN
14
Functions
Switching On / Off:
Hold down the
On/Off + Dimmer Colors
button (
10
) for a few sec-
onds to switch the lamp on and off.
Dimming:
To alter the luminosity, brie
fl
y press the
On/Off + Dimmer Colors
button sev-
eral times. There are 3 dimming levels.
Daylight Sensor:
Flip the
Indoor / Outdoor
On / Off switch (
3
) to position
Outdoor
if
the daylight sensor is to be activated. The lamp then switches on automatically when it
gets dark. To deactivate the daylight sensor,
fl
ip the
Indoor / Outdoor
On / Off switch to
position
Indoor.
Use
The battery of the lamp has to be charged up so that the LEDs can light up. If the battery
is empty, this takes approx. 4 to 5 hours.
The battery can be charged both via the solar panel (
1
) and with power from the plug
socket, depending on whether the lamp is set up outdoors or indoors.
Outdoors
1. Set up the lamp in a location where the solar panel can absorb direct sunlight all day
long if possible. Do not cover the solar panel!
2. Hold down the
On/Off + Dimmer Colors
button (
10
) for a few seconds to switch on
the lamp.
3. Flip the
Indoor / Outdoor
On / Off switch (
3
) to position
Outdoor
to activate the day-
light sensor.
The battery charges up during daylight. When it gets dark, the LEDs automatically
switch on. When it gets light, the LEDs switch off and the battery is charged up via
the solar panel.
The lamp should not be placed near to other light sources such as street lamps or
other lamps, so that the LEDs can be switched on automatically.
• To switch off the lamp manually, hold down the
On/Off + Dimmer Colors
button for
a few seconds.
• To deactivate the daylight sensor,
fl
ip the
Indoor / Outdoor
On / Off switch to posi-
tion
Indoor
.
Indoors
To ensure that the battery lasts for as long as possible, the lamp should not be switched
on during charging. Disconnect it from the mains power after charging.
1. Remove the cover from the
DC 5V
socket (
9
) on the lamp shade (
2
).
2. Plug the barrel connector on the cable (
7
) which is also supplied into the
DC 5V
socket.
3. Plug the USB connector on the cable into the mains adapter (
6
).
4. Connect the mains adapter to an easily accessible socket.
The charge control lamp next to the
DC 5V
socket lights up red while the battery is
charging. Once the battery is full, it lights up green.
