AD1200 Installer Manual, Rev. 19.06.2013 7
www.dsp-technology.com
2.19 Enter Installer Test Mode
To listen to the recorded message after recording, a telephone must be connected in parallel with
the telephone line input. If the recording is unsatisfactory you can record again. All telephone num-
bers programmed will be displayed. If telephone number is busy or not answered it will be by-
passed.
Enter installer code:
?
?
?
?
PROG
ENTER
2.20 Exit Installer Test Mode
Enter installer code:
?
?
?
?
ENTER
2.21 Enabling and Disabling of Remote Device Functionality
The hardware of the AD1200 provides as an optional feature of connecting 315 or 433 MHz wire-
less Remote Devices like Remote Controls and Remote Panic Buttons.
The Installer may enable this feature as following:
2.22 Recording a new Remote Device
The user has 4s time to activate the remote device and link it to the AD1200.
Note: If the selected location already contains another Remote Device the current location
must be deleted first (refer to 2.23) before linking a new device is possible at this location.
Press:
Press:
2.23 Deleting a Remote Device
To delete a Remote Device follow the following procedure:
2.24 Deleting all eight Remote Devices
Press: PROG
0
8
1
To disable the feature the Installer shall do the following:
Press: PROG
0
8
0
Press: PROG
2
Enter one of the eight Remote Device locations (1 … 8)
If the AD1200 is equipped with the optional Remote Device functionality and the feature is enabled
as described under 2.21 the user can now link up to eight remote devices / functions to the
AD1200. After entering
Press: PROG
2
Enter one of the eight Remote Device locations (1 … 8)
Wait for approximately 4s until an acknowledge sound is played. While this period of time do not
activate any Remote Device. Now the selected location is deleted.
To delete all eight possible Remote Devices enter the following:
Press: PROG
2
9
Содержание AD1200
Страница 1: ...AD1200 ...
