5
Section 2: TR5164 Set Up & Wiring
This section describes how to set up and wire the TR5164 module.
2.1 Unpack the TR5164
Check that the following parts are in the package:
• TR5164 PCB
• Hardware for mounting the cabinet
• TR5164 plastic cabinet
2.2 Choose a Mounting Location for the TR5164
NOTE:
Permanently mount the TR5164 receiver and wireless devices after placement testing
each device (
Section 5.1, page 11
).
Find a place that is:
• Dry
• Within operating temperature range
• Central to the proposed placement of all wireless devices
• As high as possible
• Far from sources of interference, including: electrical noise (computers, televisions and electric
motors in appliances and heating and air conditioning units), large metal objects like heating ducts
and plumbing which may shield the electro-magnetic waves.
For proper unit tamper operation, the surface that the TR5164 is mounted to should be smooth and
free of obstructions that block access to the rear of the unit.
Ensure that electrical wires do not run over and under the module when it is mounted.
When mounting the TR5164 in a basement, place the module as high and as close to the underside of
the first floor as possible. The range of the module is reduced if mounted below ground level.
2.3 Connect the TR5164
Receiver
CAUTION: Remove all power (AC, DC, telephone
lines) from the system while connecting modules to
the Keybus.
KEYBUS
TO TR5164
Connect the TR5164 to the four-wire Keybus of the
control panel according to the diagram.
NOTE:
Do not use the terminal labeled “GND.”
Once the wiring is complete, reconnect power to the
security system.
Next, enroll and program the wireless devices. See
Section 3.2, page 6
for instructions.
2.4 Tamper
The unit incorporates separate built-in wall and case tampers. The tampers are disabled by default on
the NA version (enabled on EU version). Section [804][900] options 3 and 4 enable or disable the
tampers.
When the TR5164 is properly installed, the wall tamper on the back of the unit should be depressed
by the mounting surface. If the unit is removed, the tamper activates. The case tamper activates when
the case is opened and restores when the case is closed.
NOTE:
The built in wall and case tamper must be installed and enabled for UL/ULC Listed
Commercial Burglary applications.
DRAFT