8
This section describes how to enroll and program:
• wireless devices using zones (WLS904, WLS905, WLS906, WLS907 and
WLS908)
• wireless keys (WLS909)
• handheld keypads (WLS910).
For more information on these devices, read the instruction sheet included with
each device.
3.1 A Note about Electronic Serial Numbers
An electronic serial number (ESN) is printed on the back of each wireless device.
ESNs are used to enroll the wireless devices with the PC5132-RS receiver.
In order to reduce the occurrence of wireless devices with the same serial
number, 6-digit serial numbers are now printed on the back of each
wireless device.
NOTE: 6-digit serial numbers are only supported on the following control pan-
els: PC5010 v2.x and higher, PC1555 and PC580.
The 6-digit serial numbers include hexadecimal digits. For instructions on
programming hexadecimal numbers, see your system Installation Manual,
section 4: How to Program.
When connecting the PC5132-RS to a PC5010 v1.x panel, enter 5-digit serial
numbers only. When connecting the PC5132-RS to a PC5010 v2.x and higher,
PC1555 or PC580 panel follow the instructions below.
New Wireless Device ESNs
All new devices have both a 5-digit and a 6-digit serial number printed on them
so that they can be used with all versions of the PC5132-RS wireless receiver.
When enrolling devices with the PC5132-RS:
For PC5132-RS v2.x and lower: enter the 5-digit ESN
For PC5132-RS v3.0 and higher: enter the 6-digit ESN
Old Wireless Device ESNs
You can use older devices on all versions of the PC5132-RS receiver, even
though they only have a 5-digit ESN. When using older wireless devices:
For PC5132-RS v2.x and lower: enter the 5-digit ESN
For PC5132-RS v3.0 and higher: enter [0] + 5-digit ESN
S E C T I O N 3
Enroll & Program Devices