11
11. SPECIFICATIONS
GENERAL FEATURES
System Type
Portable 6.5" 2-way bass-reflex Loudspeaker
Maximum SPL Output
105 dB @ 1 Meter
Frequency Range (-10 dB)
40Hz – 20kHz
Frequency Response (-3 dB)
60Hz – 18kHz
Audio Sources
BT / USB / FM Tuner / Aux / Mic / Guitar
/
Connectivity
Bluetooth with TWS (True Wireless Stereo)
Battery type
12V / 4Ah / 20Hr non-spillable (6FM4)
Playing time
Full power and LED Ligts ON >3.5 hours (results may vary depending of multiple conditions)
Charging time
From Low Battery <1 hour (Using AC input) <2 hour (using 12V input)
AMPLIFIER:
Power Rating
200W Music Program (Max) / 50W Continuous (RMS)
Type
Class D
Input Impedance
20k (balanced)
Input Gain
Guitar:
to +6dBu / Mic:
to +6dBu / Aux:
to +4dBu
Maximum Input Level
Guitar: -20dBu / Mic: -20dBu / Aux: +4dBu
Equalizer
4 presets and flat
Connectors
2 x 1/4” inputs: Mic/Guitar
1 x 3.5mm Stereo Jack input
1 x USB
LED Indicators
Rear Red LED (Charging mode), Top Panel Blue Ring (Unit On)
LED Speaker
Front RGB LED with color modes (switchable On/Off)
Cooling
Passive
AC Power Input
100-120VAC 50/60Hz; 230-240VAC 50/60Hz
DC Input
12V / 2A
SPEAKER:
LF Driver
1 x 6.5" woofer with 1” voice coil, ferrite magnet, paper cone
HF Driver
2 x 2" tweeter, Ferrite magnet, Paper Cone, 0.5" Voice Coil
Coverage Pattern
110 x 110 deggres
Crossover Frequency
2kHz
ENCLOSURE:
Material
Polypropylene, black
Handles
1
Grille
Preformed Steel Mesh Grill
Dimensions (L x W x H)
10.8" x 12.8" x 13.6" / 275mm x 325mm x 345mm
Weight
12.5lb
FCC Compliance Statement FCC ID: 2AYOQ-TLV6
This device complies with Part 15 fo the FCC Rules. The operation is subject to the following two conditions:
(1)This device may not cause harmful interference,and (2)This device must accept any interference received, including interference that may cause
undesired operation. Note:This equipment has been tested and found to comply with the limits for a class B digital device,pursuant to Part 15 of
the FCC Rules.These equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause interference to radio of television reception,which can be determined by turning the equipment off and then on,
the user is encouraged to try to correct the interference by one or more of the following
Measures:
“Reorient or relocate the receiving antenna.” “Increase the separation between the equipment and receiver.” “Connect the equipment to a different
outlet so that the equipment and receiver are on different branch circuits.” “Consult the dealer or an experienced radio/TV technician for help.”
