Step 1:
Press MODE selector until POWER SUPPLY lights up
STEP BY STEP POWER SUPPLY
Step 2:
Step 1:
P
Step 4 :
When the full charge LED indicator lights up, the display will show the amount
of charge absorbed by the battery.
Exmaple: If the selected battery is 40A and the indicatonis 23A, then your batter has
accumulated 23 Ah, and this is the current capacity
Step 3:
Select SL
If the display is not showing 000, hold down the READ switch until the display
shows 000
OW LOAD mode (3.1) and follow all steps described in this item.
The battery must be discharged
STEP BY STEP AUTO ICS MODE
BATTERY CHECK-UP
Step 2:
Press VOLTAGE / BATTERY selector and choose charger output voltage from
the following values: 12.6V / 12.8V / 13.0V / 13.2V / 13.8V / 14.0V / 14.2V / 14 4V
_
Step 3:
Connect the Red (+) and Black ( ) clamps to the equipment to be powered or
use the 12V socket for equipment with this connection.
Note: The Source can be constantly connected to the battery without any damage to it.
AUTO SCI MODE OPERATION DESCRIPTION
Mode when fast charging
(Phase2)
to the battery (s) is desired as it will maintain maximum
output power
(14.4V)
and will enter the SCI pulsed system (Phase 3) when the battery (s)
are charged and are in pulsating float.
Note:
Note:
When connecting an accessory such as the tire gauge, select 14.4V at the output to
get higher compressor power, and thus calibrate the tire faster
.
Step 3:
The battery will be fully charged when the full charge led lights up.
Step 1:
Press MODE selector until AUTO SCI led turns on;
_
Step 2:
Connect the Red (+) and Black ( )clamps on the battery poles
ress READ switch until VOLTAGE and CURRENT LEDs light simultaneously
Содержание BC60LP
Страница 1: ...BATTERY CHARGING STATION...
