- V -
1) OUTLINE
- WHAT IS SETUP ?
IT MEANS THAT THE FUNCTION OF EQUIPMENT IS PROPERLY SELECTED
IN ACCORDANCE WITH THE USABLE PURPOSE.
- CALIBRATION
THIS IS THE WORK WHICH INDICATES THE CORRECT WEIGHT BY
THE ADJUSTMENT OF “0” POINT PASSAGE SCOPE AND THE SCALE.
2) METHOD
- IN ORDER TO USE PROPERLY UPON THE PURPOSE OF EQUIPMENT, BE SURE
TO PERFORM THE SETUP FIRSTLY, AND THEN TO PERFORM THE CALIBRATION.
(1) WHEN IT BECOMES “POWER ON” AT WHICH “3” OF FRONT PANEL IS
PRESSED WITH POWER ON MODE, THE LETTERS OF “TEST” IS INDICATED IN
THE DISPLAY.
IN THIS TIME, WHEN “3” IS PRESSED AGAIN, THE INDICATOR SHOWS SETUP,
CALIBRATION ( S&C MODE ).
(2) IN CASE IT WILL BE ENTERED FROM NORMAL MODE TO S&C MODE,
WHEN “SET/CAL” IS CONTINUOUSLY PRESSED MORE THAN 3 SECONDS,
IT BOCOMES S&C MODE, AND THE INDICATOR SHOWS THE LETTERS LIKE
THE ABOVE (1) SECTION.
THIS MEANS THAT IT ASKS USER TO SELECT WHICH MODE OF SET UP,
CALIBRATION AND USER MODE, AND THUS IN CASE THE SETUP IS SELECTED,
PRESS “CLR” IN THE
LOWER LEFT SIDE ON KEY BOARD, IN CASE OF CALIBRATION,
PRESS “SET/CAL” IN THE RIGHT SIDE, AND IN CASE OF NORMAL MODE,
THAT IS TO SAY, USER MODE, PRESS “0” IN THE LOWER CENTER.
