EN
20
Cleaning and Storage
PLEASE NOTE!
■
Before commencing the cleaning, note the safety instructions in the “Safety
Instructions” chapter!
■
Never immerse the microprocessor unit into water,
■
Do not use any chemical, corrosive or abrasive cleaning agents or cleaning pads to
clean the device. These could damage the surfaces.
1. Remove the microprocessor unit from the pads.
2. Clean the pads under running water.
3. Let the pads dry naturally.
4. If necessary, clean the microprocessor with a slightly wet cloth.
5. When the pads is completely dry, apply the protective foil before.
6. Store the device in a clean and dry area, which is not accessible to children and
animals.
Technical Data
Article number:
01055
Model number:
PH18003
Voltage supply:
3 V DC each (2 x 1,5 V-battery, type AAA)
Output:
20 ~ 180 V
Troubleshooting
If the device does not work properly,
fi
rst check whether you are able to rectify the
problem yourself. If the problem cannot be solved with the steps that are listed, contact
the customer service department.
Do not attempt to repair a defective
electrical device yourself!
Problem
Possible cause
Solution
The signal lights
do not turn on.
No batteries have been
inserted.
Insert batteries and press
ON / HI
button.
The batteries have not
been inserted properly.
When inserting the batteries,
ensure that the polarity (+ / –)
is correct.
The battery light
turns off.
The batteries are too weak.
Insert new batteries.