19
EN
Use
PLEASE NOTE!
■
Always place the device with clear space above it and on all sides on a dry,
fl
at, solid
and heat-resistant surface.
■
Be aware that the clamps with integrated weight may likewise become hot during use.
Allow them to cool down suitably before they are detached from the item of clothing.
■
It is essential that you follow the care labels for the textiles to be dried!
Presser for blouses and shirts
1. Set the height you want. To do this, open the clip (
9
), pull
out the telescopic rod (
2
) and then close the clip again.
2. If you have not already done so, pull on the nylon balloon
(see the “Before Initial Use” chapter, “Assembly” section).
The nylon balloon should sit immediately below the
mounting
fl
ange (
8
) so that it can fully in
fl
ate.
3. Pull the garment which is to be pressed over the nylon
balloon and the hanger (
1
) and do up the buttons if neces-
sary. Make sure that
–
the collar is
fi
tted over the collar section (
10
) on the
hanger,
–
any button strip is over the hole line on the nylon balloon,
–
the arms of the nylon balloon
fi
t properly in the sleeves
of the garment and are not twisted or scrunched up,
–
all buttons on the garment (including on the sleeves) are
done up.
4. Spread the clamps along the bottom of the garment (at
the front and back in each case on the outsides and in the
middle on the button strip at the front) so that it is weighed
down and will not go out of shape when the nylon balloon
is in
fl
ated.
5. Insert the mains plug into an easily accessible socket.