Dryflow DF35DM, Инструкция по эксплуатации и каталог запасных частей, Страница: 9 / 13

7
Operation
No-touch operation.
Shake excess water from hands.
Place hands under the outlet to start operation.
Rub hands lightly and rapidly.
Stops automatically after hands are removed.
Periodic cleaning of the unit is recommended to ensure optimal performance.
Cleaning and Maintenance
Disconnect the electrical supply.
Remove the two cover-mounting screws.
Remove the cover from the dryer body.
Clean the inside of the dryer and remove any
Replace the cover. Do not over tighten the screws.
Wipe the cover with a damp cloth and mild
cleaning solution. Do not Soak. Never use
abrasives to clean the cover.
Do not flush with water.
Heater Element Switch ON/ OFF
Warm Air Speed Adjustment
SW.FOR HEATER
VR.FOR AIR SPEED
Sensor Range Adjustment
VR.FOR SENSOR
1.Switch off the power, remove the cover screws and
the cover.
2.Use a small Philips head screwdriver or a plastic flat blade
probe to turn the VR shaft. Clockwise [CW] to increase
power to maximum (+) , [CCW] to reduce power
as needed(-) .
1.Switch off the power, remove the cover screws and
the cover.
2.Adjust the heater switch on the CBM with a small
plastic or wooden flat blade probe.
2-1. Slide the switch to "ON" : heater on.
2-2. Slide the switch to "1" : heater off.
2.Clockwise: Increases the sensing range(+) .
3.Counterclockwise
:
Decreases the sensing range(-) .
4.DO NOT OVERTURN!
1.The range is 4" to 9" [100 mm to 230 mm],
standard setting is 5.12" [130 mm ± 20 mm ]
dust or lint.