Dru Babe, Инструкция по установке

Страница: 21 / 68

Dik Geurts
19
In case of a poorly running air slide, it can be disassembled
for cleaning/replacement. The air slide is spring suspended by
means of a bolt (4) and a spring (5) located below a cover plate
(3).
The plate (7) on which the slide runs can also be disassembled.
- To remove the air slide, proceed as follows
(see figure 4);
- Remove the vermiculite plates (1) from the bottom
- Remove the bolts (2) and remove the cover plate (3)
- Remove plate 11 with screws (12) or outdoor air
connection (9) with screws (10)
- Remove bolt (4) with spring (5) (hold the air slide handle)
- The air slide (6) can now be removed
- After the air slide has been removed, the running surface
can be checked for possible damages / dirt. Clean or sand
(K80) the surface.
- Apply dry-film lubrication Molykote D-321R to the running
surfaces.
- For assembling the air slide, please follow the above points
in opposite order.
●
Jannik
- Jannik was made with a lockable 80 mm outside air
connection;
- The smoke exhaust ring can be rotated to create a 130 or
150 mm diameter.
●
Jannik latch re-adjustment
- At delivery and during maintenance, please check door play
and operation of the door latch;
- If it goes stiffly or makes a noise, the following measures
can be taken;
- Lubricate the shaft of the latch with a little bit of heat-
resistant grease;
- If necessary, the door can be re-adjusted by re-adjusting
the little hollow shaft;
- By loosening the nuts somewhat and shifting the little
hollow shafts;
- Then re-tighten the nuts firmly;
- Check whether the sealing tape closes properly by
clamping a sheet of paper between the stove and the
sealing tape when closing the stove door;
- It should not be possible to pull out the sheet of paper
easily. Adjust the door, if necessary.
6. BURNING
See the User Manual , chapter 5, for lighting and burning the
fire.
7. DELIVERY
You must explain to the user how to operate the fire. You should
instruct her/him for instance on using the appliance for the first
time, heating and maintenance.
●
Instruct the user about the use of the fire.
●
When the appliance is started for the first time, point out
that
- when the fire is heated up for the first time, volatile
components evaporate from paint, materials, etc.;
- the room should be well ventilated.
●
Point out that it is necessary to have the flue duct inspected
and cleaned by a specialist, at least once per year.
●
Give the user manual and installation manual to the user (the
installation manual should be kept near the appliance).
8. MAINTENANCE
There are a number of tips/instructions on the maintenance of
the fire in Chapter 6, Maintenance, of the
User Manual . This
also explains how a number of parts can be replaced.
9. MALFUNCTIONS
In chapter 7 of the User manual you will find an overview of
malfunctions that might occur, the possible causes and the
remedies.
Appendix 1 Parts supplied
In the following table you can find the parts that are supplied
with the appliance.
Table 1: Parts included with the delivery
part quantity
Installation manual
1x
User manual 1x
Glove 1x
Ash pan
1x
Glass cleaner spray bottle 1x
Spray can of heat-resistant paint 1x