Ignis Operations Manual (DJI M600 Variant)
Drone Amplified
is triggered when S1 and S2 are twisted all the way clockwise within 2 seconds of each
other in order.
S2 NOT CCW
Dropping is disabled because the knob on the control bar labeled “S2” is
not twisted counter-clockwise all the way. This knob is used to trigger the emergency
release, and Ignis will not allow dropping until this knob is ready. An emergency release
is triggered when S1 and S2 are twisted all the way clockwise within 2 seconds of each
other in order.
HATCH MOTION ERROR
Dropping was stopped because one of the hatches had trou-
ble moving. An ignition sphere may have jammed the hatch. Try restarting to see if
the jam has been cleared. If the problem persists, land and inspect the hatches.
MOVE TIMEOUT
Dropping was stopped and disabled because one of the injection or
puncture motors had trouble moving. Dropping cannot restart until Ignis is power-
cycled. Land and inspect the injection and puncture motors. This message will only
appear on older versions of Ignis.
INJECTION A MOTION ERROR
Dropping was stopped and disabled because the
A-side injection motor had trouble moving. Dropping cannot restart until Ignis is
power-cycled. Land and inspect the motor.
INJECTION B MOTION ERROR
Dropping was stopped and disabled because the
B-side injection motor had trouble moving. Dropping cannot restart until Ignis is
power-cycled. Land and inspect the motor.
PUNCTURE MOTION ERROR
Dropping was stopped and disabled because the punc-
ture motor had trouble moving. Dropping cannot restart until Ignis is power-cycled.
This error could lead to an in-flight fire if Ignis was not able to remove an injected
sphere. Use the camera and temperature sensor to monitor for an in-flight fire and use
the emergency release in that event. Land and inspect the motor.
UNKNOWN ERROR
Dropping was stopped because of an error that the app did not
understand. Try to restart dropping. Check that you are using the latest version of
the app.
UNKNOWN HARD ERROR
Dropping was stopped because of an error that the app
did not understand, and cannot be restarted until Ignis is power-cycled. Land and
inspect Ignis. Check that you are using the latest version of the app.
Last Updated March 12, 2020
Page 16
