step one - seat/back assembly
kanga seating package
Warning!
Do not install this equipment without first
reading and understanding the instructions and parts
included with this package. Innovative concepts will not
be responsible for damage or injury as a result of misuse
or improper installation. We recommend an experienced
professional be consulted in the selection and application
process of this product.
Warning!
Until all mounting clamps, brackets and parts
are properly tightened and securely attached, make sure
client is safely supported while positioning adjustments
are made to prevent the client from falling out of the
wheelchair.
NOTE -
Seat/back assembly; “holes through upholstery”
have already been made for ease of assembly. Do not ini-
tially over tighten mounting hardware as final adjustments
will be necessary prior to fitting client into seating.
1.1
For shipping purposes only; the seat-to-back hinge is
attached to the back with only one bolt, loosen bolt and
adjust so that second bolt/washer can be installed to
securely fasten in place.
1.2
Align the seat and seat-to-back hinge to attach the
remaining two bolts/washers to bottom of seat.
1.3
Align the seat and seat-to-back hinge to attach the
remaining two bolts/washers to bottom of seat.
1.4
Align the seat and seat-to-back hinge to attach the
remaining two bolts/washers to bottom of seat.
Item Number
1300-921110
Kanga Seating Package 10” w/mounting hardware
1300-921112
Kanga Seating Package 12” w/mounting hardware
1300-921114
Kanga Seating Package 14” w/mounting hardware
Tools Needed:
5/32 allen wrench, 7/16 wrench or socket,
tape measure, pencil(1) Contoured seat.
Contents in package (qty)
(1) Contoured back
(1) #1300-7093
Left-side back hardware (hardware packet included)
(1) #1300-7095
Right-side back hardware (hardware packet included)
(1) #1300-7097
Seat knob clamp hardware
(1) #1300-7099
Seat-to-back hinge bolt packet
