Item Number
1072-34410
Kanga Thigh Supports, Removable, 10” (pair)
11072-34412
Kanga Thigh Supports, Removable, 12” (pair)
11072-34414
Kanga Thigh Supports, Removable, 14” (pair)
Tools Needed:
5/32 allen wrench
Contents in package (qty):
(1) Mounting base hardware packet
(2) Thigh support assembly, flush mount with pads
(attached)
(2) Upper mounting brackets, 1inch Offset (optional use)
kanga thigh supports,
removable
NOTE -
The 12inch and 14inch contoured seats come
with multiple thigh support mounting base t-nut locations,
it is best to dry-fit hardware in-place prior to cutting
upholstery. This installation is easiest with the contoured
seat removed from the wheelchair, lying bottom side up
flat on a solid surface.
1.1
Locate the spring loaded pull knob on bracket(s), to
remove simply pull knob and lift up on contoured pad. To
re-attach simply align upper bracket into seat mount base
receiver and push-click into place.
1.2
Locate the desired (2) t-nut holes (through upholstery)
on the bottom of contoured seat to attach the mounting
base (see note above), carefully cut upholstery to access
t-nuts.
1.3
Using the mounting base hardware packet, attach (2)
screws/washers through the mounting base slots and
secure to the contoured seat. Repeat steps for opposite
side.
assembly
