3
Assembly Instructions Cont.
3. Connect the head spring
by aligning with foot spring
and swinging both ends away
from each other. (Continued
on next page)
2. The lock collar comes pre-set from
the factory. Ensure that it is 1/4” -
1/2” away from hanger bracket. If
not, slide lock collar 1/4” from the
foot side of the hanger bracket as
shown. Tighten thumb screw.
Note: The rail is marked full or semi as
a guide.
1/4” Gap
Thumb Screw
1. Install drive shaft onto foot section.
