Prism Electric Scooter
Page 11 of 15
Owner’s Handbook (Code: Z40949 Rev A)
3. Unlock the front
wheel and tiller by
pulling the wheel
lock catch up.
4. Loosen the tiller
adjustment knob,
raise the tiller to the
desired position,
and then tighten
the tiller adjustment
knob.
5. Reinstall the
battery pack by
lowering it in to
place.
6. Replace the seat
and rotate it until it
locks in to its
correct position.
After assembling the Prism, make sure the
tiller adjustment knob is fully tightened.
8. TROUBLESHOOTING
•
The troubleshooting guide is also featured on page
1 for the Owner’s Handbook.
Problem: Scooter will not switch on
Symptoms:
Batteries not connected
Circuit breaker has tripped
Rear and front sections not
connected
Remedy:
Check batteries connected
Push circuit breaker to reset
Check connection on front-
to-rear loom
Problem: Scooter will switch on but will not run
Symptoms:
Flat batteries
Charger plugged in
Motor in freewheel mode
Remedy:
Recharge battery
Unplug charger from scooter
Push down freewheel lever
Problem: Scooter appears slow
Symptoms:
Flat batteries
Speed setting slow
Remedy:
Recharge battery
Turn up speed dial
Problem: Seat moves whilst in use
Symptoms:
Seat not locked in position
Remedy:
Slowly rotate the seat until it
drops in place and is secure.
Problem: Tiller appears loose
Symptoms:
Tiller adjustment knob loose
Remedy:
Tighten tiller adjustment
knob
Problem: Horn sounds involuntarily / automatically
Symptoms:
The scooter has diagnosed a
fault
Remedy:
Ensure the wigwag paddle is
released and switch the
scooter off and on.
Recharge batteries if error
persists.
