10
User Manual Ecotec 2G
Drive Medical GmbH & Co. KG | As per: 28.11.2017 | Subject to error and change
EN
Assembly
Attach wheels and unfold
Attach the wheels by pressing the unlock button in the
middle of the hub and insert the wheel into the desig-
nated socket on the base. Please make sure that the
wheels are properly locked before use, by pulling the
wheel towards you away from the wheelchair. (Picture
1+2).
Unfold the wheelchair by pushing the seat until it locks
in place.
1
2
Mounting footrests
Mount both footrests as shown in and move them to
the inside until you perceive a clear audible snap. Pull
the lever upwards and move the footrest to the outside,
in order to release/ remove them. (Picture 3+4).
3
4
Adjusting length and inclination of footrests
ADJUSTING LENGTH
(Abb. 5):
Open and remove screw
on the back side of the
footrest with the allen key
and adjust the length to fit
your needs.
Check where the threa-
ded hole is and install the
locking screw.
Tighten screws!
Adjusting seat height
The height of the seat can
be adjusted in 3 positions.
Remove both wheels by
pushing the release but-
ton in order to adjust the
height..
Open the nut on the wheel
receiver and move it to the
desired drilling. Install the
nut with the lock washer
and tighten it. (Picture 6).
Make sure the nut is securely tightened!
Adjusting sitting height (front wheels)
The sitting height in the
front can be adjusted in
3 positions as well as the
desired inclination. (Pic-
ture 7).
Remove the screw from
the axle in order to adjust.
The plugs in the holes are
easily replaced.
Adjust the height and tighten the screw.
Make sure the axle is securely tightened!
Adjusting and removing armrest
When delivered, the armrest are already mounted to
the wheelchair. The armrests are replaceable. Depen-
ding on your requests, the armrests can be set as short
or long armrests. To adjust, loosen the screws on the
bottom and adjust the armrest to the desired position.
(Picture 8+9).
Tighten the screws again!
9
8
To fold back the armrest, you must push the lever on
the front of the armrest and pull back the armrest at the
same time. (Picture 10+11).
11
10
